Adhesives

Chemicals

Frames

Misc Supplies

Mesh

Murakami Emulsions

Ulano Products

Wilflex Inks

Curing
Gel/Flash cure: 155 F. (68 C.) Due to differences in power, height above ink film and efficiency of flash unit, a specific dwell time for flashing cannot be given.

Full Cure: 300 F. (149 C.) Failure to cure ink properly causes poor washfastness and unacceptable adhesion.

Modifiers
None. This product should be used straight out of the container

Wash Up
Conventional solvents or Bio-degradable Chemicals.

Print at high production rate
Low ink build-up
Wide standard color range
Very Competitive Pricing

Premier Series Plastisol Ink

Premier Series (PRM) plastisol inks have been specifically formulated by Freedom for wet-on-wet screen, high productivity printing. Premier inks offer opacity and vibrance in a wide spectrum of colors. They have excellent resistance to build up and excellent ease of printability.

Opacity: Excellent

Curing Time
Gel or flash-cure: Approx 230 F
Full cure: 320 F
Cure tests should be made prior to any production run. Failure to cure properly may cause increased dye migration, poor wash fastness and inferior adhesion.

Printing Recommendations

Mesh

86-120 mesh for optimum opacity.
120-280 mesh for overprinting and fine line printing
305-355 mesh for process printing.

Squeegee 60 to 90 Durometer, straight edge blade.

Emulsion Conventional direct or capillary films.
Caution: Special pigments are required to manufacture One-Step Nylon fluorescent colors. Do not trap or overprint on top of fluorescent colors.